Thursday, November 19, 2009

How to get TV to channel 3?

I have a Panasonic TV/VCR combo. I turn the TV on and all I get is a blue screen. I have AT%26amp;T Uverse for a cable to get different channels. I tried the TV remote and the cable Uverse remote. Neither do anything other than turn the TV on and off. When i go the the channel controls on the bottom of the TV and run through them, I can go through the channels but it skips channel 3. It starts on channel 2 and jumps to channel 8? How do I get to channel 3?

How to get TV to channel 3?
On the TV/VCR remote, make sure it's set to TV mode and press 03 , then Enter....





If that doesn't work, make sure your UVerse cable box is turned on, then use your TV/VCR remote to access the TV menu....





In the menu, look for a Channel or Autoprogram mode....


You might find those located in SETUP....





And you MAY have to set your remote control to the VCR mode if you don't find it....


Then just AUTOPROGRAM it....





Autoprogramming makes the tuner scan all available channels, locks out unused channels and locks IN channels that are present on your TV's Antenna connector....





That's why you want your UVerse box turned on....IF your TV doesn't see the UVerse's Channel 3 it will not lock in on it.....
Reply:batteries dead?
Reply:plug in the number 3 in your remote
Reply:Are the batteries in the remote dead?





Is there a menu button on the front of the television? The problem is that channel 3 isn't programmed in to the memorized channels on the TV.





Personally I'd ditch the VCR in favor of something with RCA inputs...I realize that doesn't help your situation, but just my two cents.
Reply:does it have a number pad? if it does, just type channel 3, hit menu, and hit add channel

tooth extraction

No comments:

Post a Comment